View Single Post
  #6  
Old 08-21-2017, 09:30 AM
RantNRave RantNRave is offline
Enthusiast
 
Join Date: Jan 2016
Location: Sugar Land, TX
Posts: 33
Hey Chris.

I've actually purchased a couple of your DVDs (streaming) on slip joints so I've seen how you make the washers. I've also purchased Don's book in which he describes the relief milling. Reconciling the two ways is what caused me to raise the question here.

By the way, I used your tutorials to build my own etcher, so you're reaching us noobs out there!

-Dan


__________________
Dan Hargrove
Too many interests, and not enough time!
Reply With Quote