ok one other ??? the data sheet says....
" Quench: Oil or positive pressure (4 bar minimum) to below 125?F (50?C), or salt quench to about 1000?F (540?C), then air cool to below 125?F (50?C). Salt bath treatment, if practical, will ensure the maximum attainable toughness for a given hardening treatment. "
so I could either quench in oil all the way through by it self OR positive pressure (4 bar min) all the way through by it self right NOT a combination of both like you would do with cpms35vn right? am I also right to assume if a 2 bar min (like cpms35vn) is 30 psi so 4 bar wouyld be 60 psi?
|