View Single Post
  #3  
Old 09-30-2017, 08:09 PM
jimmontg jimmontg is offline
Guru
 
Join Date: Jan 2016
Location: Now live in Las Cruces NM.
Posts: 1,345
Do the scales have to be titanium? Would aluminum serve just as well? Just wondering, what do the originals have? Reason I ask is that titanium is not what your average machine shops keep in stock, they usually only order it for a specific job as it is expensive, but some may have some cut-offs in stock. It is also a bit on the hard side to machine, but no worse than stainless, they both wear out end mills.
Reply With Quote