|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
another DUH moment
OK guys so I had one of those DUH moments.....yes again! so I got a piece of DAMAsteel at the knife show the other day. planed on using it for bolsters there is only enough for maybe bolsters on 2 knives so not enough for a full blade. how ever I was thinking about it and here is the duh moment. if I etch it before putting it on I willgrind away the pattern along with the excess of pins. and idk how I could etch it after they are on and ground how can I etch them and not mess the finish up on the blade. .....the only way I see of doing it is mounting them with screws like would be done on a folder and maybe a lil bit of glue not a lot cause I wouldn't want it to squeeze out the sides where I would have to grind it off and hit the side of the bolster.....I am just wondering if any one has any other ideas how this may work that I might be overlooking
|
Tags |
back, blade, bolster, bolsters, damascus, easy, epoxy, etch, folder, glue, grind, grinding, handle, hardware, knife, knife show, knives, material, pattern, pins, rivets, sanding, screws, show, small |
Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A DUH Moment! | Hurley | The Newbies Arena | 8 | 11-09-2013 08:54 AM |
A moment of silence | Drac | Knife Network Community | 12 | 09-14-2007 02:02 PM |
An Historical Moment! | Tim Adlam | Knife Network Community | 0 | 03-11-2003 10:08 PM |
A moment of silent prayer | wrathlord | Knife Network Community | 1 | 01-09-2003 09:49 PM |
Just lifting my crosses for a moment , Please. | Geno | Tool Time | 7 | 05-22-2001 08:02 AM |