|
|
Register | All Photos | FAQ | Members List | Calendar | ShopStream (Radio/TV) | Search | Today's Posts | Mark Forums Read |
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ATS-34
Hello Guys I am going to purchase some ATS-34 of admiral steel. The 1/8 is cold rolled and the 3/16 is hot rolled could anyone tell me the difference between the two and if i have to heat treat them any different. Thanks Ben Hall bjhall@vic.australis.com.au |
#2
|
|||
|
|||
Take a look over on the S.R. Johnson forum page. There is a thread on some issues with cold rolled ATS-34. |
#3
|
|||
|
|||
They should heat treat the same. Personally, I would recommend 154CM from Crucible myself. Contact info is as follows: Crucible Bruce Di Vita                        www.crucibleservice.com 1101 Avenue H East Arlington, TX 76011 (817) 640-7777 (800) 365-1168 This is the same basic steel as ATS34 but I understand that Crucible has a little vanadium in their 154CM where ATS34 does not. Besides, its 'merican made! Craig |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
(View-All) Members who have read this thread : 1 | |
22H2 |
Thread Tools | |
Display Modes | |
|
|