|
|
The Supply Center What's Hot ... and where the deals are! Supplies are our specialty ... |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
looking for a .223 size drill vit
I am looking for a .223 for holes on my tang,so the corby bolts will work through the female part on a corby is .218 I want a snug fit .give me so input thanks,do you know were I can get some. |
#2
|
|||
|
|||
Find a hardware store that carries wire gauge numbered drill bits. The #1 is .228 and the #2 is .221. These are the closest ones I've seen to .223. Good Luck. |
#3
|
|||
|
|||
Nathan, Doug is right on track, the .221 will work fine. I have access to metric drill bits and sometimes use a 5.7mm bit which is about .224, but after they wear a little I usually get a .223 hole in the tang. If you can't find a #2 bit send me your address and I'll send you one. Mike |
#4
|
|||
|
|||
Any of the suppliers below should have what you need. Craig ------         Wholesale Tool Co.        www.wttool.com/         Michigan 800-521-3420                Indiana 800-551-2251         Massachusetts 800-343-1008         North Carolina 800-438-3580         Oklahoma 800-331-4075         Florida 800-237-4689         Texas 800-231-4585                 MSC Industrial Supply Co.        www.mscdirect.com         Call: (800) 645-7270         Fax: (800) 255-5067         See website for locations                         Enco        www.use-enco.com         Tel: 800-873-3626         Fax: 1-800-965-5857                 J&L Industrial Supply         Tel: 800 521 9520                 IGF Industrial Supply Company        www.igfsupply.com         101 Coin St. at I35W         Ft. Worth, TX 76140         Tel: 800-657-8925                 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
(View-All) Members who have read this thread : 0 | |
There are no names to display. |
|
|