A place to start...

[csc]

here is my first engraving on anything other then a copper prectice plate. Its not much but it is a place to start. All coments welcome, and thanks for looking.
Chad

[jacques herbst]

It Is A Good Start

[Jim Small]

Chad
Nice piece of work for the first try.......
I was just messing around doing some doodles and thought I might complicate things a little. These might give you another starting point. Copy these and give them a try.
These were done very quickly and change them anyway you want.
Great first job!
Jim

[csc]

Thank you, I will give them a try tomorrow or at least get a start on them. I will post a pic when they are done.
Chad

[billrice@charte]

Jim
You continue to amaze me with your generosity. You are always willing not only to help out others with great advise, you are also willing to give others a help with your talent.( reminds me of someone else like Steve L., Bertil A., Ron Nott etc.)
Thanks for always giving a helping hand.

Bill

[rhrocker]

That's a nice pattern Jim! Chad, you're off to a good start for sure.