|
|
Fine Embellishment Everything from hand engraving and scrimshaw to filework and carving. The fine art end of the knifemaker's craft. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
engraved dagger
Here is a dagger I just finished. The handle is redwood burl with siver wire. The guard is stainless, I broke a lot or graver tips on it.
|
#2
|
||||
|
||||
Beautiful work Dave.What series of stainless did you use for the guard as some are much easier on gravers than others.Some engravers wont even touch some of the 300 series.416 is great,although not as stain resistant as the 300's.
__________________ N'T McAhron Sqwaukin Vulture Verrinder "to create is to make art" TREMBLING EARTH KNIFE WORKS |
#3
|
|||
|
|||
Thanks McAhron,
Im not sure on the stainles. It was a left over chunk from a hand railing. probably 316 |
#4
|
|||
|
|||
Nice work. I like that dagger VERY much.
I was also thinking the guard is perhaps in the 300 series. I've seen a lot of comments that 300 stainless is tough and the recommendation is to stay away from it! Peter |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|