400 series stainless steel

[gail]

Hello,
I was wondering if anyone could give me a source for stainless steel sheet, 1/16" thick, in small quantity. A 3 x 6 inch sheet or thereabouts. I have tried to find some on the internet but haven't had much luck. I see there is plenty available if I want to buy it by the roll.... LOL but I am 67, and doubt if I could use that much before exiting this world, even if I could afford it. I am looking for 400 series range that is relatively easy to engrave. Thanks Gail.

[Joe Mason]

These guys may have what you want.

http://www.admiralsteel.com/

Joe

[Russ Sutton]

Originally Posted by gail

Hello,
I was wondering if anyone could give me a source for stainless steel sheet, 1/16" thick, in small quantity. A 3 x 6 inch sheet or thereabouts. I have tried to find some on the internet but haven't had much luck. I see there is plenty available if I want to buy it by the roll.... LOL but I am 67, and doubt if I could use that much before exiting this world, even if I could afford it. I am looking for 400 series range that is relatively easy to engrave. Thanks Gail.

You might try www.onlinemetals.com at the following: http://www.onlinemetals.com/merchant.cfm?id=793&step=2

They have 410 stainless in 12 x 12 inch pieces 1/16 inch thick.

Russ

[gail]

Joe and Russ,
Thanks for the leads. I surely appreciate it. Gail

[ron p. nott]

hi gail .. try the knife suppliers like Sheffield knife supplies in flordia , I buy 410 by the 2ft. x2 ft . sheet .. ron p.