Here I
will try to show you how I do a back to back arrowhead
pattern. I
hope you enjoy this project and if you are going to try
it "Good Luck and Have Fun"
I marked the blade spine off in 1/4
inch sections.You can do this at whatever size you would
like.
Tools needed are a ruler,scribe,small
round file,3 corner file,and something to hold the
blade in stationary prefferably a vice,but you can
clamp the
blade to the side of a board that is clamped to the
table if thats all you have available.
You will use 2 sections to make 2 arrowheads
pointing each other.The first cut is with the three
corner file on the line between the two sections.
You want the first cut almost to center.then
file a flat at a angle back to shape one side of the
point.You can stop this at ever point that you want,I
keave enough room for the round file's thickness.
Continue
this tutorial
.
|
