Thread: Oyster Knife
View Single Post
  #1  
Old 03-12-2013, 01:22 PM
miketheknife's Avatar
miketheknife miketheknife is offline
Steel Addict
 
Join Date: Dec 2012
Location: High Point, NC
Posts: 196
Oyster Knife

I have been asked by a buddy to make him a custom oyster knife. No problems making the knife, however, in all my searching I cannot find any info about HT'ing or not HT'ing. I will be making it out of 1084. Will the rounded over edges be strong enought to open a stubron oyster or clam if it has not been HT'ed?

Thanks, Mike
Reply With Quote